Help fixing chuffing Annie

I have some of these 8mm 14 tooth gears (I don't remember what gearbox I had that needed them, but it was something I worked on recently). I took apart a different chuffing Annie just to see if the mechanism was any different by chance but it is the same.


I took the partial gear off to compare it and it looks like it pretty much lines up with the 14 tooth gear. I'd go with that.





When I eventually get to covering one of the sets the chuffing Annie was included in I will include some of this repair information. It may end up being mentioned on the Shuppo D51 page as a variant of the mail car as well.

That's awesome DuckGWR thank you! Time to buy some gears. Thank you for your help.

Update: Done. I also ordered a 142.5A for Annie's wheel gear even though it's perfectly fine right now.

Hey everyone I did it. Thank you DuckGWR & everyone for your contributions.

So I'll try not to make this long winded; I got my gears today and picked out what I needed plus my spare rods
  
I measured and cut both the 2mm and 2.5mm thick rods to size thanks to DuckGWR's measures, put the gears through them, cut down the spokes on the 14T gear to 5
          
Put everything back together again it sounds like how I imagine it should sound like with original gears.

Thanks again to everyone for their contributions.

[Super]

OMG...Awesome...Fantastic work Mitza. Great job 👍👍👍

Amazing! Yes that is pretty much exactly what my chuffing Annies sound like. Glad you could get it working again!