The New 3D Printing Thread

395 Replies, 293830 Views

(03-02-2025, 05:29 PM)Destination Realization Wrote: HOLY COW!!! AWESOMEEEEEE
Too bad my local Makerspace is closed today Sad I would’ve printed it already

thank you!!
I do rather hope someone prints him eventually, I would be glad to know if he actually fits the chassis or not 😅
[-] The following 2 users Like DrMopp1966's post:
  • DalaGStanator, Destination Realization
A great looking design! It must have been a lot of work to model all the details.

Here's my first attempt, it works but it does not answer your question:

[Image: printed-Toby-1.jpg]

I don't have any spare official mechanisms but I do have some of my own making but these need the body to be slightly altered.
[-] The following 2 users Like Densha's post:
  • DalaGStanator, DrMopp1966
thanks!! I do have a chassis I 3d modelled to build him around, but again that wouldn’t really answer the question of if it fits the official one or not. lovely to see him printed out though!!
(This post was last modified: 03-10-2025, 05:50 PM by DrMopp1966.)
[-] The following 1 user Likes DrMopp1966's post:
  • DalaGStanator

Test run.

Speed can be adjusted with the knob at the back of the engine. Due to its wider wheels it only just fits through the car wash!



Lessons learned include that control by a knob on the back end of a little engine is not a great idea for use with full-size fingers.
[-] The following 3 users Like Densha's post:
  • DalaGStanator, Destination Realization, Donald9Douglas10Oliver11mp
Looks good Den 👍
[-] The following 1 user Likes Super's post:
  • DalaGStanator
fantastic!! lovely to see him going along
[-] The following 2 users Like DrMopp1966's post:
  • DalaGStanator, Destination Realization



Users browsing this thread: 4 Guest(s)