Custom Trackmaster Talking Flynn w/ Flashing Led lights

4 Replies, 6523 Views

While working on putting in a headlamp on Plarail Connor and Caitlin, i was going to add a pair of headlamps in Flynn.  I then realized i had some flashing red leds that i purchased for another project.  I figured i would give them a try and i think it turned out pretty well.  The Leds come on when the motor is engaged and go off when Flynn is lifter from the track (due to a safety sensor in the rear battery car).  (This will be on eBay soon, as it was built to sell, PM me or post in the trading zone if interested).  Thanks. 

[Image: F10-C23-EF-32-A7-44-AF-AB40-2-BAA8-FC995-DB.jpg]

[-] The following 2 users Like ripley802's post:
  • DalaGStanator, Super
Thats awesome Ripley. How many volts does Flynn run with to drive two LED's?
Thanks Super. Flynn has 3 AAA that he uses. The LEDs are 2-5v I believe.
[-] The following 2 users Like ripley802's post:
  • DalaGStanator, Super
So I assume that the 3 AAA's are run in Series for 4.5volts?
Yep, all of it runs to the factory circuit board which controls how much goes to each component I believe. I have not measured it with a volt meter but it may only be around 2v at the motor/led lights.
[-] The following 2 users Like ripley802's post:
  • DalaGStanator, Super



Users browsing this thread: 1 Guest(s)