The New 3D Printing Thread

I defiantly need help... So I've been working on my GNR 4 wheel coaches and well the 6 comp. 3rd body (without interior and roof detail) is complete:





Also I've almost finished the 4 comp. 3rd brake, however I've run into a slight problem... You see I only have a photo of the side of the coach and as for the ends I've been using photos of the preserved 4 wheel 5 comp. 3rd and the 6 wheel brake 3rd, but I the ends are giving me a headache. The GNR coaches had two ends 1 with a curved handrail and steps:



And an end with a wire/ pipe for presumably the lighting:



Now the end with the steps is usually on the side of the doors with a handle, but on the photo of the 4 wheel 3rd brake that I have a curved handrail and step can just be seen witch would go against every other GNR 4 and 6 wheel coach I've seen?

If anyone can find a photo of specifically a GNR 4 wheel 3rd brake it would be a huge help!



[/url][url=https://postimg.cc/gxjDPW82]