I'm using the mingda magician X but with a .2 mm nozzle, rather than the usual .4 mm, although I'm not certain if the mesh pieces are going to print..
It has surprised me in the past, like with the clarity of the vents above the doors..
I've found that I have to use a raft for these prints and with the .2 mm nozzle the top of the raft is quite slippery so the first layer is often a bit of a mess... Currently I haven't found a solution but I 'll keep trying
It has surprised me in the past, like with the clarity of the vents above the doors..
I've found that I have to use a raft for these prints and with the .2 mm nozzle the top of the raft is quite slippery so the first layer is often a bit of a mess... Currently I haven't found a solution but I 'll keep trying
The magic of the GWR
![[-]](https://www.blueplastictracks.org/images/collapse.png)