The New 3D Printing Thread

Hi Ron,

Thanks for the info, I'll have a crack at printing some using PLA then, my 'main' printer at the moment is a Tronxy XY2SE, but I also have an older Ender 3 Pro.  Most things that print on the Ender are fine on the Tronxy so I'll just give a few a go and see how they come out

What I had in mind as further items would be a slope and/or bridge compatible with the Advance loco's, I know there were some made, but I'm not sure if the gradient was ideal for Advance even though they were supposed to be made for the system, I also don't have any so could never find out unless I come across some these days.  Also I wondered if you'd thought about trackside buildings etc...


Cheers, Nigel