FfarquharDeveloper's TrackMaster Customs

1/17/21 LETS GO

Rheneas:
- Moving rods have been added onto him making him way cooler imo, based on @tomynewacoliver's Rheneas siderod modification.


Rusty:
- Face removed for downscaling using Shrink-It (to be purchased) -- Face was removed by using a heat gun, some tweezers, a craft knife, a file, and a lot of force (I do not recommend using Hit Toys Rusty for this modification, use a TOMY Rusty instead it's much easier with the screws.)
-- Heat gun was used to soften the pegs, then a file was used to sand them down along with tweezers to try and break it, additionally, a craft knife was used at the bottom, this was repeated until the pegs were flush, at that point the radiator and face were pried off by hand, both were held in by glue. 
- Body primed and radiator filled in, awaiting further sanding before airbrushing.


Derek:
- Test fitted shell on chassis for the first time after being repainted.
- Masked up to add another coat of green (not pictured).


???:
- what??
- mmm wait and see, this'll take a few days