The New 3D Printing Thread

Here we go, pictures of the print, not the best pictures and the model has literally just been printed, cleaned and cured, it still needs a bit of cleaning up and an undercoat.  The particular resin I was using, translucent blue, is not the best for showing the detail either, however you can see some detail that the FDM printers couldn't cope with such as the bits along the top of the windows.  You will also see the printing fault I mentioned on the third picture (3 diagonal lines) I think these are artifacts from a line that should run along the top of the side just below the edge of the roof, looking at my model it looks as thought it isn't quite as close to the model side as it should be and being loose has slipped and adhered to the side instead.  I'll have to tweak the model to fix that, but it shows promise