I like to use 'green stuff' epoxy putty, mix the blue and yellow together to get a green plastacine type material that drys in air
I agree with ucwepn, dremels are great, but you might be better sanding. I also use a stanly knife and a junior hacksaw, I've also been known to use a heated blade too as it cuts through the plastic easily. But, However you cut plastic, it always seems to leave a rough edge, so you will need to file and sand if you want a good surface finish
(This post was last modified: 01-03-2017, 08:44 PM by Tramp.)
I agree with ucwepn, dremels are great, but you might be better sanding. I also use a stanly knife and a junior hacksaw, I've also been known to use a heated blade too as it cuts through the plastic easily. But, However you cut plastic, it always seems to leave a rough edge, so you will need to file and sand if you want a good surface finish