Repairing Replacing Broken Wires

18 Replies, 22430 Views

I agree.. Fix it. But be prepared. Once you repair one and. See how much fun it is you may be hooked. I replace the motor in a bash or dash and then was hooked after that. Replacing the wire is not that bad. Just try and get the same gauge wire as if you get to big it will cause issues in turns and too small it would be very delicate. Good luck and post back with any questions as I am sure we have are most all scenarios. Lots of expierence and help on these forums.

Messages In This Thread
Repairing Replacing Broken Wires - by Nickel - 09-05-2014, 03:07 AM
RE: Repairing Replacing Broken Wires - by Ucwepn - 09-05-2014, 04:22 AM
RE: Repairing Replacing Broken Wires - by Super - 09-05-2014, 05:14 AM
RE: Repairing Replacing Broken Wires - by Tramp - 09-05-2014, 02:18 PM
RE: Repairing Replacing Broken Wires - by Super - 09-05-2014, 03:07 PM
RE: Repairing Replacing Broken Wires - by Super - 09-11-2014, 01:15 AM
RE: Repairing Replacing Broken Wires - by Nickel - 09-11-2014, 01:21 AM
RE: Repairing Replacing Broken Wires - by Super - 09-11-2014, 01:35 AM
RE: Repairing Replacing Broken Wires - by Nickel - 09-11-2014, 01:46 AM
RE: Repairing Replacing Broken Wires - by Super - 09-11-2014, 01:59 AM
RE: Repairing Replacing Broken Wires - by Ucwepn - 09-11-2014, 02:32 AM
RE: Repairing Replacing Broken Wires - by Tramp - 03-26-2016, 11:26 AM
RE: Repairing Replacing Broken Wires - by ripley802 - 03-26-2016, 11:41 AM
RE: Repairing Replacing Broken Wires - by Super - 03-26-2016, 08:58 PM



Users browsing this thread: 8 Guest(s)