No pics of this, but the other day I made a very simple "wheel puller" of sorts. At first I had twisted the wheel which stripped it. After having to super give that one I wanted to come up with something a bit easier.
Basically I took a small piece of aluminum I had laying around which was about 1/8" thick. I cut a small slit in it the width of the axel and then about 1" long. From here basically I slip the wheel assembly in and position the device on a vise. I used a small punch but other tools would work to tap out the axel.
Now it is ready for the new gear.
I also am making the same jig I made above out of aluminum so that it is a bit more compact and easy to use.
Basically I took a small piece of aluminum I had laying around which was about 1/8" thick. I cut a small slit in it the width of the axel and then about 1" long. From here basically I slip the wheel assembly in and position the device on a vise. I used a small punch but other tools would work to tap out the axel.
Now it is ready for the new gear.
I also am making the same jig I made above out of aluminum so that it is a bit more compact and easy to use.