The New 3D Printing Thread

376 Replies, 266752 Views

Would that before the Trackmaster Revolution (Trackmaster II)?
To be honest I'm not sure Super, I may print one just to see as its not obvious from the pictures...
Happily collecting things all my life... Big Grin
(This post was last modified: 10-19-2019, 11:34 PM by Super.)
[-] The following 1 user Likes Nigels's post:
  • Super
Would your printer print something this long or would it have to be split to two?
https://www.thingiverse.com/thing:3320643/files
[-] The following 2 users Like drew5195's post:
  • chrisjo, Super
In case Nigels doesn't know...this Tomy Monorail track is 17.5".

So Drew, are you moving from Mini's to motorized Plarail?
(10-21-2019, 06:58 AM)drew5195 Wrote: Would your printer print something this long or would it have to be split to two?
https://www.thingiverse.com/thing:3320643/files

It is feasible using my CR10s (as opposed to my workhorse Ender 3), but it would require printing them at a diagonal angle with supports, the pictures below are the model loaded and quickly sliced on Cura for the CR10s.  This would need some tweaking as I'm not convinced looking at the picture previewing the supports (last pic) that they would be sufficient.  But that is part of the modelling process prior to printing.

[Image: Tomy-Monorail-01.png]
[Image: Tomy-Monorail-02.png]
[Image: Tomy-Monorail-03.png]

[Image: Tomy-Monorail-04.png]
Happily collecting things all my life... Big Grin
[-] The following 1 user Likes Nigels's post:
  • drew5195
The latest print off my Ender 3 using a 'purple glitter PLA', not train related, but I think it looks awesome Smile

[Image: IMG-20191021-195641.jpg]


[Image: IMG-20191021-195701.jpg]
Happily collecting things all my life... Big Grin
Wait...it printed in 2 colors?
did you print the crystal ball at the same time?
My Trackmaster/Tomy/Plarail Photo Gallery Page (over 600+ photos and still under construction)
https://www.flickr.com/photos/183311600@N03/
(10-21-2019, 09:10 PM)Super Wrote: Wait...it printed in 2 colors?

No I printed the crystal separately Smile

The best part is the model is designed so that there is a hole in her right hand which leads to the hollow arm and down the body to the bottom, so you can wire an LED in to illuminate the crystal Smile

Mind you it would be possible to print in two colours using a CR-X Wink
Happily collecting things all my life... Big Grin
(10-21-2019, 08:14 AM)Super Wrote: In case Nigels doesn't know...this Tomy Monorail track is 17.5".

So Drew, are you moving from Mini's to motorized Plarail?

Was never into mini. You must be thinking another Drew.

Thanks Nigels for pictures. I asked as track is rare. Might see if i find some local to print it for me.



Users browsing this thread: 31 Guest(s)