+- Blue Plastic Tracks (https://www.blueplastictracks.org)
+-- Forum: Blue Plastic Tracks (https://www.blueplastictracks.org/forum-36.html)
+--- Forum: Show Us What You Bought (https://www.blueplastictracks.org/forum-13.html)
+--- Thread: 2009 trackmaster Rocky battery cover (/thread-1074.html)
Pages:
1
2
RE: 2009 trackmaster Rocky battery cover - Super - 03-11-2019
Its funny, I must be getting old as I have repaired wires in 4 or 5 Rocky's and I can't remember if I had any trouble taking it apart. Guess its time to put Super out to pasture.
BTW...welcome to BPT's Roman!
RE: 2009 trackmaster Rocky battery cover - ripley802 - 03-11-2019
Super, I am in the same boat. I am not thinking there was anything specific in getting it apart other than the screws at the bottom. However it has been a few years since I have had one apart. If anything there may be clips on the black bottom piece.
RE: 2009 trackmaster Rocky battery cover - Super - 03-11-2019
I have been thinking about this for a while and I can't come up with anything that I had trouble with. Roman, why don't you take a small flat head screwdriver and gently pry on all four sides to see if that would persuade whats holding it back to give up its grip? A broken wire is very common on Rocky so once you repair one of these you become an Rocky expert.
RE: 2009 trackmaster Rocky battery cover - Romanspoppop61 - 03-11-2019
Thanks to all. The base has the 2 clips on each side. They do give slightly but with a fight so I will try this again carefully. This piece is in almost a 10 condition so I have to use much care. Have a great day!
Update, pried base from end, popped off. There are 2 small posts that anchors the base, shown with the Sharpe end, however 1 post broke but does not affect the integrity of the base.
![[Image: 0311190737.jpg]](https://i.postimg.cc/8sf2XFxB/0311190737.jpg)
RE: 2009 trackmaster Rocky battery cover - Romanspoppop61 - 03-11-2019
Also I have plenty of same gauge wiring from the Thomas junkyard. However this gauge wire is delicate to strip. Any easy ways to do this? I usually melt the ends off with soldering pencil tip. Luckily the break is right at the coupler area.
Luckily I have this gauge wire in my Thomas junkyard. Any easy ways to strip the ends?. I usually melt it off with the soldering pencil tip.
RE: 2009 trackmaster Rocky battery cover - Super - 03-11-2019
I just use a small gauge wire stripper but I know not everybody has them as you usually can't find them in local Home Improvement Centers or Hardware stores but can be had cheaply on the Internet. Keep up the good work Roman
RE: 2009 trackmaster Rocky battery cover - Romanspoppop61 - 03-11-2019
Tks much. Time to solder and see what happens.